HORIZONTAL CENTRIFUGAL PUMPS
DIABLO
SINGLE STAGE HORIZONTAL CENTRIFUGAL PUMP
Designed and engineered to feed filter presses; can be supplied with single or dual speed motors, with pump-motor cupling via belts and pulleys or direct coupling via coaxial coupling.
Depending on the version you can have flow rate range from 100 l/min to 10,000 l/min with closed pressures up to 8-9 bar.
The bodies and impellers can be made of superalloys.
The suction inlet is positioned in such a way that sludge does not come into direct contact with the michanical seals, wich are made of tungsten carbide, drained with water and protected by a pressurised barrier chamber.
TECHNICAL SPECIFICATION
AXLE
Horizontal pump axle with sealed chamber bearings sized to allow the front of the shaft to work as a cantilever without supports immersed in the liquid.
COUPLING
By means of belts and trapezoidal pulleys with protective casing.
BODY
Made of cast iron divided into two halves with protective coating in our special moulded wear-resistant compound, consisting of replaceable shells that can be adjusted from the outside, both to allow rapid and convenient replacement and to eliminate any play caused by normal wear. With axial suction inlet and discharge outlet facing upwards.
GIRANT
Anti-clogging, made of abrasion-proof superalloy.
SEALING UNIT
Composed of a double flushed seal.
BASE
Steel frame to support the pump on the floor.